A little knowledge about mass air flow sensors

What happens when your car’s Mass Air Flow Sensor is contaminated?

Ans: Well, you probably may not notice it but have already experienced it first hand when your car engine idles roughly or suddenly stalls. A contaminated Mass Air Flow Sensor will send the wrong airflow information to the engine’s computer. The computer will miscalculate the amount of airflow due to the lack of information and deliver too little fuel, making the idle rough and stalling out the engine at times.

What happens when your car’s Mass Air Flow Sensor is contaminated?

Ans: Well, you probably may not notice it but have already experienced it first hand when your car engine idles roughly or suddenly stalls. A contaminated Mass Air Flow Sensor will send the wrong airflow information to the engine’s computer. The computer will miscalculate the amount of airflow due to the lack of information and deliver too little fuel, making the idle rough and stalling out the engine at times.

So do we have to replace the Mass Air Flow Sensor if it is contaminated?

Ans: No, you can easily clean it with YASEN’s Air Flow Sensor Cleaner! It is a special active solvent spray for fast and gentle cleaning of sensitive components of the Mass Air Flow Sensor in both gasoline and diesel engines. This product can completely remove the contaminants such as oil, grease or dirt on the hot wire or the hot plate of Mass Air Flow Sensors without leaving any residues.

What are the benefits of YASEN Air Flow Sensor Cleaner?

Ans:

• It is very easy to use
• It provides excellent cleaning effect
• Fast evaporation after cleaning and free of residues
• More economical as you do not need to replace the MAF Sensor
• Gives you a better driving experience

When do we need to use YASEN Air Flow Sensor Cleaner?

Ans: Well, if you are already facing rough engine idling or stalling, you should use it to clean your MAF Sensor immediately to see the results! As for preventive measure, it is strongly recommended to clean your mass airflow sensor every 6 months, or every time you change your engine oil. You may also clean it when you change or clean your air filter, that will be a good way to save both time and money.

 What will happen if we don’t use this product?

Ans: We can ignore most parts of the car getting dirty but definitely not the Mass Air Flow Sensor. A contaminated Mass Air Flow Sensor will cause annoying problems initially such as engine stalling, and eventually causes your car to breakdown completely when the contamination becomes even more serious.